china slurry pump wet end parts

Mixers can also help agitators when pumping very dense particles. In applications where the tank is small and/or where pumping is desired to lower the water level in the tank, a slurry pump with an internal cooling system should be considered to avoid overheating of the stator (when the water level gets low). When pumping sediment from a dam or lagoon, consider the use of a raft unit, which is a submersible device. Agitators are recommended, as well as one or more mixers that can be mounted on the raft or pump to resuspend particles for successful pumping of particles.

Although the focus of slurry pumps is often on the size and percentage of solids to be pumped, in many applications corrosion resistance is also an important factor in material selection. In such cases, the material chosen must provide adequate resistance to erosion and corrosion.

With the standard flush schedule, the flow is usually adjusted by compressing the packings until a few drops of water are observed leaking from the seals on the drive side. In a quench schedule the flow rate is set by adjusting the inlet valve, while a valve is used on the exhaust side to maintain the correct seal tank pressure. If the outlet water from the seal box is too hot, the flow rate is increased until the outlet water cools, while still maintaining the correct seal box pressure.

Flushing is defined as a fluid which is introduced into the seal cavity on the process fluid side, close to the seal face, and is normally used to cool and lubricate the seal face.

Customised pumps

Step 4

Insulation: Insulate the air conditioning hoses, especially in areas where they pass through hot or humid environments. Proper insulation helps maintain the efficiency of the cooling system and prevents condensation.

In conclusion, there are four different sizes for auto A/C hose in the most common car air conditioning system. If the vehicle is a bus or coach, it will be a bigger A/C hose, like 7/8 inch and 1 1/8 inch. Make sure which part of A/C hose is broken, like hose from compressor to condenser, you can know the exactly hose size.