high quality hydraulic submersible slurry pump manufacturer

WA series target=_blank title=Heavy-Duty Slurry Pump>heavy-duty slurry pump is cantilevered, horizontal, natural rubber or hard metal lined centrifugal slurry pumps. They are designed for handling abrasive, high density slurries in the metallurgical, mining, coal, power, building material and other industry department.

It is critical to determine the right slurry pump size and power requirements for your application. Depending on the abrasive nature of the slurry, it is important to select a pump size that will allow it to run at a slow enough speed to extend the life of the slurry pump. The ideal RPM to run a slurry pump is between 900 and 1200 RPM. Once that speed is started to be exceeded, the life of the pump is greatly reduced because the wear points of the slurry pump are actually sandblasted.

>Slurry Pump

Submersible slurry pump pumps offer many advantages over dry and semi-dry (cantilever) mounted pumps.

Slurry pipe diameter.

First, what is a slurry? A slurry is a semi-liquid mixture, usually consisting of fine particles. Examples of slurries can include manure, cement, starch, or coal suspended in water. There are countless other combinations that can be considered slurries. Because of the added particles and thicker consistency, special pump requirements should be considered. A standard pump may be able to handle the fluid, but not as effectively as a properly sized slurry pump.

The deep groove design is particularly advantageous for radial loads, as it enables the bearing to support forces that act perpendicular to the shaft's axis. Additionally, the deep groove configuration allows the bearing to accommodate some degree of axial load, although axial load capacity is typically lower than radial load capacity in deep groove ball bearings.