Dredge Pump

- transport solids hydraulically

Vertical Slurry Pump

In dry installation, the hydraulic end and drive unit are located outside the oil sump. When using a submersible slurry pump for dry installation, the slurry pump must always have a cooling system installed. Consider the design of the water tank in order to deliver slurry to the pump. Agitators and side-mounted agitators cannot be used for this type of installation.

It is critical to determine the right slurry pump size and power requirements for your application. Depending on the abrasive nature of the slurry, it is important to select a pump size that will allow it to run at a slow enough speed to extend the life of the slurry pump. The ideal RPM to run a slurry pump is between 900 and 1200 RPM. Once that speed is started to be exceeded, the life of the pump is greatly reduced because the wear points of the slurry pump are actually sandblasted.

Aier Machinery's team of consultants are on hand to provide you with a solution to your needs. Whether you are planning to purchase a slurry pump or need spare parts for an existing pump, we will help you determine your needs and provide advice on fine-tuning your equipment to your specific application.

Overnight news titanium dioxide industry

Food containing titanium dioxide that is lawfully placed on the EU market before 7 August 2022 may remain on the market until its date of minimum durability or its ‘use-by’ date has passed. Food produced or placed on the market after 7 August 2022 cannot contain titanium dioxide. The ban on the use of titanium dioxide is effective in each EU Member State, and in Northern Ireland. Some third countries, such as the United Kingdom (excluding Northern Ireland), continue to permit the use of titanium dioxide.

3. Safety measures The MSDS should provide recommendations for safe handling, storage, and disposal of lithopone. This may include guidelines for personal protective equipment, proper ventilation, and spill response procedures.

Still, in 2016 Skittles publicly declared it would get rid of the chemical compound in its products, according to a press release at the time from the Center for Food Safety, which called the substance harmful and potentially poisonous. But the ingredient remains, according to the lawsuit, which alleges the candy company is misleading consumers by not having eliminated titanium dioxide.

This work confirms previous studies that show P-25 and other untreated anatase 377 nanoparticles should not be employed in sunscreens because the toxicity of P25TiO2NPs under UV radiation is significant.

Studies of titanium dioxide as a food additive suggest health dangers

Applications of Lithopone Powder:

Our scientific experts applied for the first time the 2018 EFSA Scientific Committee Guidance on Nanotechnology to the safety assessment of food additives. Titanium dioxide E 171 contains at most 50% of particles in the nano range (i.e. less than 100 nanometres) to which consumers may be exposed.  

Although barium sulfate is almost completely inert, zinc sulfide degrades upon exposure to UV light, leading to darkening of the pigment. The severity of this UV reaction is dependent on a combination of two factors; how much zinc sulfide makes up the pigments formulation, and its total accumulated UV exposure. Depending on these factors Lithopone B301, Lithopone B311 powder itself may vary in shade over time, ranging from pure white all the way to grey or even black. To suppress this effect, a dopant might be used, like small amount of cobalt salts, which would be added to the formulation. This process creates cobalt-doped zinc sulfide. The cobalt salts help to stabilize zinc sulfide so it will not have as severe a reaction to UV exposure.

Barium sulfide is produced by carbothermic reduction of barium sulfate. Zinc sulfate is obtained from a variety of zinc products, often waste, by treatment with sulfuric acid.

Nanoparticles