high quality slurry pump for vapor blasting

What is a dredging pump?

- Pumping the final product in a process

Dredge pumps are designed to transfer large quantities of fluids and solids.

The FGD process begins when the limestone feed (rock) is reduced in size by crushing it in a ball mill and then mixed with water in a slurry supply tank. The slurry (approx. 90% water) is then pumped into the absorption tank. As the consistency of the limestone slurry tends to change, suction conditions can occur which can lead to cavitation and pump failure.

Consider the impeller. Slurry pumps must have thicker vanes than water pumps to prevent wear. Due to the increased thickness, there will be fewer vanes, otherwise the passages will be too narrow and will affect the performance of the pump. The impeller should have a large enough passage so that the largest solid particles can pass through without clogging.

When the slurry pump working, pump parts are easy to be impacted, wear, and corrosion, etc. Therefore, the liner of the slurry pump uses wear-resistant material, such as high chromium alloy, rubber. The wear-resistant materials can effectively reduce the wear parts of the pump. So most of the slurry pump is a wear-resistant slurry pump in the current market.

The polymerization of resin monomers was initiated in the presence of nanofibers as structural templates to prepare a hydrogel with nanofibrous networks, followed by the drying and pyrolysis to get hard carbon aerogel. During polymerization, the monomers deposit on templates and weld the fiber-fiber joints, leaving a random network structure with massive robust joints. Moreover, physical properties (such as diameters of nanofiber, densities of aerogels, and mechanical properties) can be controlled by simply tuning templates and the amount of raw materials.