china oem fgd pump factories

You should use a minimum of two half-lapped layers of vinyl tape to insulate and jacket low-voltage components. A half-lap (see Figure above) consists of overlaying each turn by one-half the width of the tape. The general rule of thumb calls for a tape thickness of 1.5 times the thickness of existing wire or cable insulation. In every case, tension on the tape should be sufficient to conform the tape evenly to the surface. A slight reduction in tension is encouraged for the final wrap. Trim the tape end and allow it to return to shape before pressing down with the thumb to avoid lifting or flagging.

Double-Coated Polyethylene Foam Tape

The application process of Flex Tape is straightforward, adding to its appeal. To use, simply cut the desired length, peel off the backing, and press it firmly onto the surface needing repair. It’s advisable to clean the area to ensure maximum adhesion. Once applied, Flex Tape immediately begins to bond, and in most cases, further reinforcement is not necessary. This ease of use makes it accessible for individuals without extensive DIY experience while still appealing to seasoned professionals.

In production plants and manufacturing facilities where steam, dripping water and elevated humidity are present, self-fusing rubber tapes provide much needed moisture protection.

Understanding the Control Box: A Comprehensive Guide