slurry pump for vapor blasting factories

These seals are more commonly used in pumps, motors both electric & hydraulic, gearboxes & occasionally dirt wipers in hydraulic cylinders. They help protect shafts and bearings from dirt and harmful contaminants entering the internals of the application that they are fitted to, as well as prevent any leaks of lubricant.

Now, slid the o-ring to fit into the shaft.

Among the most common causes of oil seal failure are:

Dimensions

Finding oil spots under a parked vehicle can be both worrying and stressful for any vehicle owner. If the seal’s leak is small, oil may start to accumulate on the underside of the engine. But as the leak gets bigger, the oil leak will become visible in the front side of the engine.  

No single physical property of rubbers is responsible for the successful performance of an oil seal or ‘O’ ring. The ultimate tensile strength, breaking elongation, modulus, shore hardness, creep and stress relaxation in tension and compression loads are all important physical properties that characterize a seal or ‘O’ ring. Compression strength and set together with stress relaxation or decay are important for effective sealing. The difference in these properties in a swollen seal is highly critical. An optimum swelling value in a fluid medium is a desirable feature. De-swelling decreases the seal pressure against the wall of the housing where the seal is fixed, leading to leakage. Over swelling minimizes the physical properties of the rubber. Seals made of polysulfide rubbers have extreme fuel resistance but undesirably high compression set. The effect of temperature on the seal is an important factor. Swelling under stress can increase at higher temperatures and a suitable compounding technique should be adopted to reduce this effect.