high quality casting slurry pump part manufacturers

A slurry is a mixture of fluids, which consists of a water-like liquid and particles. Typically, slurry acts in the same way as a viscous, sticky fluid - moving with gravity - but usually needs to be pumped.

Advantages of rubber

Slurry Pump Impeller Size

- Pumping media where abrasive particles are present

Slurry Pump Considerations

Choosing the right pump for your slurry is critical to getting the most out of it. Basic pump components such as impeller size and design, materials of construction and discharge configuration must be considered to ensure that the pump can withstand the wear caused by abrasive slurries. Compared to low-viscosity liquid pumps, target=_blank title=Slurry Pump>slurry pumps are typically larger and often require more horsepower to operate because they are less efficient. Bearings and shafts must also be more robust and durable.

Even though it’s better than other materials in terms of toughness and wear time, it is preferably used in dry-running applications. The salient demerit of this material is its cost.

Next, apply a small amount of grease to the seal lip(s) and the area of the shaft in contact with the seal.  When using a double-lip seal, fill the small cavity between the two lips with grease as well. This both protects the lips during initial installation and break-in, and also acts as another barrier keeping contaminants out. When installing rubber-coated seals, apply lubricant to the outside diameter as well. This will help prevent the seal from rebounding or backing out from its mounting place.

Operating conditions such as the engine’s temperature, position, size, pressure and shaft speed largely determine which individual oil seal composition is most suitable for every individual application.

Oil seals work by squeezing and retaining lubricant in a thin layer between the lip and the shaft. Perfect sealing is ensured by the hydrodynamic action of the rotating shaft, which in turn produces a slight pump action.

In this kind of seal, wider tolerances are possible between the OD of the seal and the seal housing. Irregularities of the housing surface can be taken up by the resilient rubber layer on the outside of the seal. However, the rubber covered seal can be blown out under high pressure in a reciprocating application whereas, with a metal case, there is no such danger.