wn dredge pump factory
Latest articles
How much solids damage can the customer tolerate?
wn dredge pump factory...
wn dredge pump factory 【wn dredge pump factory】
Read MoreSome models can generate discharge pressures up to 260 ft. (80 m).
wn dredge pump factory...
wn dredge pump factory 【wn dredge pump factory】
Read MoreBCT Ceramic Slurry Pumps
wn dredge pump factory...
wn dredge pump factory 【wn dredge pump factory】
Read MoreSelecting And Operating A Slurry Pump
wn dredge pump factory...
wn dredge pump factory 【wn dredge pump factory】
Read MoreA slurry is a mixture of fluids, which consists of a water-like liquid and particles. Typically, slurry acts in the same way as a viscous, sticky fluid - moving with gravity - but usually needs to be pumped.
wn dredge pump factory...
wn dredge pump factory 【wn dredge pump factory】
Read More>Dredge pumps are a special category of pumps used in the dredging process. Dredging is the process of transporting submerged sediments (usually sand, gravel or rock) from one area to another. Dredging takes place in the shallow waters of lakes, rivers or seas for land reclamation, dredging, flood control, new harbours or expansion of existing harbours. The various industries that use dredge pumps are therefore the construction industry, mining, the coal industry and the oil and gas industry.
wn dredge pump factory...
wn dredge pump factory 【wn dredge pump factory】
Read MoreKeep in mind that slurry pumps are designed to adapt to specific pumping conditions. Pumps used in the cement industry handle most fine particles at low pressures, so the casing can be of lightweight construction. In rock pumping, the casing and impeller must be able to resist slamming, so they must be built thick and strong.
wn dredge pump factory...
wn dredge pump factory 【wn dredge pump factory】
Read MoreSlurry Pump VS Mud Pump
wn dredge pump factory...
wn dredge pump factory 【wn dredge pump factory】
Read MoreWe know that the right rubber and ceramic liners work very well. They also last longer and can withstand more demanding use. They can also be replaced, thereby extending the life of the pump while reducing operating costs. You can also customise your pump with a variety of ceramic parts, including bushings, pump housings, impellers, wet ends and even seals.
wn dredge pump factory...
wn dredge pump factory 【wn dredge pump factory】
Read MoreTypical Applications of slurry pump
wn dredge pump factory...
wn dredge pump factory 【wn dredge pump factory】
Read More
Popular articles
- How to Choose a Dredging Pump or Slurry Pump
- The same point of slurry pump and mud pump
- Submersible Slurry Pump
- If you have experience pumping slurry, you know it is not an easy task. Slurries are heavy and difficult to pump. They can cause excessive wear on the pump and its components, and if they don't move fast enough, they can clog the suction and discharge lines. Most importantly, it can be a challenge to keep a slurry pump in use for a reasonable period of time. However, there are steps you can take to extend the life of your slurry pump and reduce the challenges of pumping slurry.
- These mud pumps can pump not only sand, but also more mud. They are very effective in pumping all forms of mud, gravel, concrete, slurry, slush, etc.
- Slurry pump design
Latest articles
-
Aier Machinery has strong technical force and is specially engaged in the research of abrasion resistant materials of slurry pumps, sewage pumps and water pumps and the development of new products. The materials include high chrome white iron, duplex stainless steel, stainless steel, ductile iron, rubber, etc.
-
Stainless Steel, Duplex Stainless Steel, Ductile Iron, Grey Iron, etc. We can also provide natural rubber, elastomer rubber parts and pumps.
-
The basic mechanical seal flushing programme is very simple. It requires that a clear/clean fluid (usually water) is introduced into the space between the actual seal and the impeller side outlet restriction. The flushing fluid is introduced at a pressure higher than the pumping pressure, thus ensuring positive outflow/flushing of the mechanical seal and a clean operating environment.
-
Sites often rely on centrifugal pumps to provide slurry service. These pumps (and their associated piping systems) require special provisions that demand detailed knowledge of the properties of solids and slurries to prevent wear, corrosion, erosion and other adverse effects such as solids settling. Specifying the optimum combination of speed, geometry and material requires a proper balance of often conflicting pump priorities; this requires consideration of stable operation, maximum wear life, operational flexibility and minimum energy consumption.
-
With the standard flush schedule, the flow is usually adjusted by compressing the packings until a few drops of water are observed leaking from the seals on the drive side. In a quench schedule the flow rate is set by adjusting the inlet valve, while a valve is used on the exhaust side to maintain the correct seal tank pressure. If the outlet water from the seal box is too hot, the flow rate is increased until the outlet water cools, while still maintaining the correct seal box pressure.
-
Other manufacturers looking for differentiation, if not the end result, may choose to add a small part to their pump assembly in the description, thus allowing in-line adjustment of the wear ring in the suction side lining assembly.
Links
The error of construction welding net diameter should be controlled at 0.02 mm. For example, we buy wire diameter of 89 wire welding net, with a micrometer to measure the diameter, the diameter of the allowable range is 87 -91 wire. In this range is qualified welding net. Because the accuracy has been compared, but no one can control it so well in the production process. The welding net can be accurate to 0.01 mm, so the error is allowed.
Post time: 21-10-22To many people, a dog cage looks like a prison, but for dogs who have been raised on cage training, it is their home and shelter. A cage should be a comfortable place. Never put a dog in a cage for no reason. They will see it as punishment. (Why do many dogs fail to adapt to their owners’ commands, because whether the paparazzi can come out or not, it is also seen as a punishment.
Post time: 13-03-23
Post time: 27-03-23
Post time: 10-08-22- Galvanized iron wire is divided into hot galvanized wire and cold galvanized wire, using low carbon steel wire processing, after drawing molding, pickling rust removal, high temperature annealing, hot galvanized, cooling and other processes. It has good toughness and elasticity, and the amount of zinc can reach 300 grams/square meter. It has the characteristics of thick galvanized layer and strong corrosion resistance. Galvanized iron wire can be cut off in the construction of the tie wire, the length of 20cm, 30cm and 40cm, can be cut off according to requirements.
- 2.0*2.0mm 12 m/kg
Post time: 11-07-22
Post time: 19-04-23Fence use: The use of the fence is generally one meter two to two meters a height of the impregnated welding mesh, mesh mostly 6cm, wire diameter from 2mm to 3mm.
Titanium alloy with low carbon content is obtained because the carbon content remains the original concentration. The hardness of titanium alloy is mainly related to its carbon content. Therefore, after carburizing and subsequent heat treatment, the workpiece can obtain the performance of hard and tough inside. Galvanized wire varieties are mainly classified into three categories: electric galvanized wire, hot galvanized wire and galvanized wire. Among them, the classification of galvanized wire is divided into large roll galvanized wire, medium roll galvanized wire, small roll galvanized wire, galvanized shaft wire, truncated galvanized wire and other main production varieties.
2. Eliminate caked zinc residue on zinc liquid surface
Galvanized wire is processed from low carbon steel wire rod, after drawing forming, pickling rust removal, high temperature annealing, cooling and other processes. Galvanized wire is widely used. Electroplating temperature should be controlled at 30 to 50℃. Because the chloride ions in the bath are very corrosive, quartz glass heaters are generally used.
Because zinc layer corrosion resistance, can be applied to all kinds of environment, use is also very convenient, has been more popular hardware products. Galvanized iron wire should pay special attention to the acyl washing, to slowly put into the container, to prevent acid sputtering on the body, and prohibit the water into the water, so that it is easy to let the acid out, to learn to handle gently, stacking should also be firm and neat. It can be widely used in architecture, handicrafts and other daily civilian applications.
- Barbed rope used to circle cattle and sheep and other livestock also has one of the biggest characteristics is that the price is relatively cheap, for users engaged in breeding industry, investment is not small, the use of barbed rope to fence on the one hand is to reduce the cost, on the other hand is better protection effect.
Stainless steel barbed wire in the way of corrosion is not too, because the surface is not treated but relies on its own raw materials for corrosion resistance, so there will be no chemical reaction.
The height of the shield should not be less than two meters. The length of the shield should be the width of the journey and the extension 10 meters away. The vertical load of the handrail on the bridge is 1.2KM/m, and the horizontal external load is 2.5KM/m, both of which should be calculated separately. Galvanized hook mesh belongs to a hook mesh, it is the selection of galvanized wire, hot-dip galvanized wire as raw materials, woven through the hook mesh truncated.
- A. When the thickness of the plating is 3-4 mm, the zinc adhesion should be less than 460g/m, that is, the average thickness of the zinc layer is not less than 65 microns.
- Barbed wire welding is the reason for the occurrence of black spots is because the welding wire action to be timely in the melting time, development should be appropriate, no argon, long time burning, current, distance, tungsten needle blunt, molten pool temperature is high, is the root cause of blackening. Continuous burning, is about the active welding machine energy selection, machine welding will appear black spots.
Post time: 07-06-22- 2. Preheating: Put the steel wire into the preheating furnace to increase its temperature in order to better react with the molten zinc liquid.
- The last is the size of the barbed rope or blade barbed rope. The commonly used size is good, especially for some special-shaped products, which need to be mentioned repeatedly in the production process of the barbed rope factory to avoid unnecessary losses.
- The drawing process of the waste product has a great influence on the function of the product. The general selection of about 90% of the larger total surface reduction rate (see area reduction rate) and the smaller pass surface reduction rate (about 23%), to ensure the endurance of the product. On the high strength spring steel wire, pulling should be controlled each time the temperature of the steel wire outlet is lower than 150℃, to prevent the steel wire due to strain aging and change the crack, which is the main drawback of steel wire waste.
Customers do not need to worry about the impact of the production cycle when ordering products from the thorn rope factory, because the overall treatment is now focused on the waste gas, so the production of thorn rope should be said to have the least impact. Customers ordering products in the thorn rope factory can rest assured that the delivery time this piece, can provide customers with goods on time. If the production cycle is not affected, then customers will be more assured of the thorn rope factory.
The prepared black wire welding net is placed in environmental protection galvanized equipment for galvanized treatment. The surface of galvanized welding net is evenly covered with a layer of metal zinc. The corrosion resistance of zinc is very good and it is not easy to be oxidized. The wire diameter error of galvanized welding mesh is very strict, and the gap should be controlled at about 0.02 mm. But whether the tension of an electric welding mesh is qualified, can only be tested by professional tools.
- 4, safety, environmental protection, harmless to people (livestock), even if it does not intend to touch the guardrail will not hurt like steel, iron guardrail. Stainless steel wire mesh can be used as poultry cage, egg basket, channel fence, drain tank, porch guardrail, anti rat net, mechanical protective cover, livestock and plant fence, grid frame, etc.