high quality trash slurry pump suppliers

All products are mainly supplied to environmental protection, wastewater treatment, urban water supply and drainage, mine, metallurgy, coal, petrochemical, building material, thermal power FGD, river dredging, tailing disposal and other fields.

The impeller is considered the heart of the dredge pump and is similar to a fan that expels air and creates centrifugal suction. At the suction pipe, this vacuum absorbs the slurry and transports the material through the discharge line.

Critical to the engineering of the pump are heavy duty bearing frames and shafts, extra thick wall sections and easily replaceable wear parts. Total life cycle cost considerations are critical when specifying pumps for severe operating conditions, such as FGD service. High chrome pumps are ideal due to the corrosive pH of the slurry.

To reduce component wear, most centrifugal slurry pumps run at fairly low speeds - typically less than 1200 rpm. Find the optimum position that allows the pump to run as slowly as possible but fast enough to prevent solids from settling out of the slurry deposit and clogging the lines.

A dredge pump contains a pump casing and an impeller. The impeller is mounted in the pump casing and connected to the drive motor via a gearbox and shaft. The front part of the pump casing is sealed with a suction cover and connected directly to the suction pipe of the dredger. The discharge port of the dredge pump is located near the top of the dredge pump and is connected to a separate discharge line.

For certain types of slurry pumping conditions, positive displacement pumps may be a more suitable option than centrifugal pumps.

   - Spherical Roller Bearings: Spherical roller bearings are designed to primarily support heavy radial loads and moderate axial loads. Their unique design includes barrel-shaped rollers guided by inner and outer ring raceways with a common spherical raceway on the outer ring, allowing them to accommodate misalignment and axial displacement. They are commonly used in applications where heavy radial loads, shock loads, and misalignment are present, such as in heavy machinery, mining equipment, and industrial applications.