②

Once you have selected the most suitable seal available, considering the environment, temperature, shaft speed, pressure, lubrication availability, as well as the size, of course, the seal should be stored adequately and then fitted properly. Here are a few suggestions that could help:-

Fluorine rubber (FKM, Viton™)

Oil seals are commonly used in engines, gearboxes, and other rotating machinery to prevent the leakage of oil from shafts and bearings. They are typically made from rubber or elastomeric materials that are resistant to oil and heat. The seal is installed in a housing or bore that is larger than the shaft, and it is pressed against the shaft to create a tight seal.

Spring The spring supplements the tightening force (i.e., the lip radial load) to ensure enhanced sealing performance and tight contact between the shaft and the sealing edge.The spring also prevents the deterioration of main lip sealing performance caused by high heat or other such factors.

Wear and oil loss remains two of the most frequent signs of engine seal failure and, if not paid attention to, it can give rise to a breakdown in the vehicle’s system. Regular maintenance and routine oil changes minimize the issues associated with oil seals and potential oil loss. 

ERIKS type M (type B according to the DIN standard) has a single metal casing and rubber sealing lip. Since the casing is made of metal, it must be fitted in a well-finished, undamaged groove. Large volumes of oil seals with metal casings are often cheaper, which is why they are often used as original equipment in machines. However, if an oil seal has to be replaced, types with a rubber exterior (type R or RST) are easier to fit. Type MST is similar to M and commonly used. The difference is the dust lip in the MST oil seal that prevents dust and dirt reaching the sealing lip, and extends its service life in dusty environments.