warman slurry pump australia manufacturers

Latest articles



Links

  • To remove surface active substances by matting with activated carbon. Or filtration to make the foam less stable, which are effective measures; Other measures should also be taken to reduce the amount of surface-active substances brought in to Z. The electroplating speed can be significantly reduced by the introduction of organic matter. Although the chemical formula is conducive to a high deposition rate, the coating thickness cannot meet the requirements after the organic matter is loaded, so activated carbon can be used to treat the tank.

  • 3. The front and back twist barbed wire has a beautiful appearance
  • Because the coal resources are exposed on the surface of the open pit coal mine, it is more important to protect and prevent coal theft. The erection and use of barbed rope in these places are better than other products. The barbed rope factory recommends suitable barbed rope products to everyone.

  • Weigh each reel of wire of different specifications, not less than the reel weight required in the contract, and record the value. Contact detection. No contacts are generated for each reel of wire. If there are contacts, no more than three contacts are generated for each reel. Each contact should be smooth surface treatment, the wire can not be pulled off from the contact, in line with customer packaging requirements.
  • The positive and negative twisting barbed wire is less than 3 cents per meter, and the corresponding 12 hot dip galvanized barbed wire is 5 cents per meter, no matter from the service life, tensile strength, rust prevention effect is no worse than the 12 iron wire
  • 2.0*2.0mm indicates that the two strands are 2.0mm silk, and the barbed wire wrapped around the strands is also 2.0mm silk.
  • 1. Zinc layer thickness: under normal circumstances, the thicker the zinc layer, the better the corrosion resistance of electrogalvanized wire. This is because the increase in the thickness of the zinc layer can improve the self-corrosion performance of the zinc layer and form a better protective layer.
  • Hot dip galvanizing is then oiled and chromed. The quality of hot-galvanized sheet produced by this method is significantly improved compared with that by wet galvanizing method. It is only valuable for small-scale production. Continuous galvanizing production line includes a series of pretreatment procedures, such as alkali degreasing, hydrochloric acid pickling, water washing, solvent coating, drying, etc., and the original plate needs to be annealed in cover furnace before entering the galvanizing line.

  • Blade barbed rope production links need to be many times before the finished product, roughly down to four or five links.

  • Galvanized

  • Many luxury cat, dog, parrot, bird and flock cages use square iron tubes. Luxury cage using iron square tube is generally as a cage body frame, and then on each side of the welded iron wire. Square tube cage is characterized by more beautiful shape design, cage body more solid, more surface treatment methods.

  • Removal of surface-active substances by activated carbon matting. Or make the bubble unstable according to overworry, these are all reasonable countermeasures; Other strategies should also be used to minimize the amount of surfactant taken in. The introduction of organic matter can make the electroplating process speed drop sharply. Galvanized iron wire blackening can be effectively prevented, such as: the work site to keep dry, reduce and do not use chemicals, operators with clean gloves and so on. In addition, hot dipping zinc factory can be required, after dipping zinc must be passivation treatment, passivation treatment of zinc has a better anti-discoloration effect, can effectively prolong the discoloration time, the combination of the two, discoloration should be able to solve. Galvanized iron wire has good toughness and elasticity, the amount of zinc can reach 300 g/square meter. It has the characteristics of thick galvanized layer and strong corrosion resistance.

  • After passivation treatment of galvanized layer, it can generate a layer of bright old and beautiful color passivation film, which can significantly improve its protective performance. There are many kinds of galvanized solution, according to its properties can be divided into cyanide bath and cyanide bath two categories. Cyanide zinc plating solution has good dispersion ability and coverage ability, the coating crystal is smooth and meticulous, simple operation, wide application range, in the production is used for a long time.

  • Dog cage mainly to welding, spraying, injection molding, electroplating surface treatment, dog cage using high quality steel wire, dog cage surface treatment are spray, plastic, electrophoresis, chrome plating, galvanized, imitation gold, etc., can be processed according to customer requirements, can also be customized, the structure of the dog cage compact assembly, clean and beautiful appearance, make folding and dismantling cage more convenient and quick, will not take up too much space.

  • In order to make the zinc content of steel wire stable in the future, and maintain its uniformity, as far as possible to reduce the zinc content, and effectively reduce zinc consumption to the actual work, the following measures are proposed by the wire factory:


  • Post time: 30-09-22
  • barbed


  • Post time: 30-05-22
  • hook

  • First of all, we need to pay attention to the material of the barbed wire, because the galvanized barbed wire itself includes cold plating and hot plating. The properties and prices of the two are obviously different, and it is easy to be confused by a little negligence.


  • Post time: 19-08-22
  •  


  • Post time: 12-06-24
  • barbed

  • Strictly control the pH value of large roll galvanized wire bath, research shows that the size of the bath pH value directly affects the quality of steel wire coating, improper control of pH value will cause loose coating. When the pH value is greater than 3, the steel wire coating has burr caused by fine dendrites, and the surface is not smooth. The current density is strictly controlled. From the microscopic morphology, the higher the current density, the larger the zinc layer grain deposition, the less dense the corresponding zinc layer.