>Slurry Pump VS Mud Pump

These mud pumps can pump not only sand, but also more mud. They are very effective in pumping all forms of mud, gravel, concrete, slurry, slush, etc.

Slurry Pump

Choosing the right pump for your slurry is critical to getting the most out of it. Basic pump components such as impeller size and design, materials of construction and discharge configuration must be considered to ensure that the pump can withstand the wear caused by abrasive slurries. Compared to low-viscosity liquid pumps, target=_blank title=Slurry Pump>slurry pumps are typically larger and often require more horsepower to operate because they are less efficient. Bearings and shafts must also be more robust and durable.

Sites often rely on centrifugal pumps to provide slurry service. These pumps (and their associated piping systems) require special provisions that demand detailed knowledge of the properties of solids and slurries to prevent wear, corrosion, erosion and other adverse effects such as solids settling. Specifying the optimum combination of speed, geometry and material requires a proper balance of often conflicting pump priorities; this requires consideration of stable operation, maximum wear life, operational flexibility and minimum energy consumption.

Slurries are divided into two main categories: non-settling or settling. Non-settling slurries consist of very fine particles, giving the illusion of increased apparent viscosity. These slurries usually have low wear characteristics, but require very careful consideration when selecting the right pump, as they behave differently from ordinary liquids.

In order to contribute with experimental evidence that could help to achieve a better understanding of the field for future regulation, in the present work, the biocompatibility of commercial P25TiO₂NPs (one type of TiO₂NPs used in sunscreen formulations) and two novel functionalized P25TiO₂NPs were evaluated under solar simulated irradiation. White light, generated by red, blue, and yellow LEDs, together with UV ones, was chosen to simulate the solar spectra. Functionalization of TiO₂NPs was made with antioxidant vitamins in order to prevent the expected photo-initiated ROS production when nanoparticles are exposed to the simulated solar spectra. Vitamin B2 (riboflavin) and vitamin C were chosen to carry out the functionalization because they are water-soluble, low-cost, and are a constitutive part of biological processes. In addition, it is known that both have the potential to prevent macromolecular oxidation by ROS [23], [24], [25], [26].