For more information about this new and improved pump, please contact us.

Consider the impeller. Slurry pumps must have thicker vanes than water pumps to prevent wear. Due to the increased thickness, there will be fewer vanes, otherwise the passages will be too narrow and will affect the performance of the pump. The impeller should have a large enough passage so that the largest solid particles can pass through without clogging.

In a subsea installation, the slurry pump runs directly in the slurry and does not require a support structure, which means it is flexible and easy to install. If possible, the catch basin should be equipped with sloping walls to allow sediment to slide down into the area directly below the pump inlet. Agitators should be used when the liquid contains large amounts of solids and has a high particle density. Freestanding or side-mounted (submersible) mixers are an excellent choice for resuspended solids, especially if the catch basin is large or does not have sloping walls.

sets or tons on high chrome alloy castings. Main products are Type WA, WG, WL, WN, WY, WZ, etc. Size: 25-1200mm,

Horizontal pumps are the most commonly used type of slurry pump and therefore have the advantage of being easy to install or maintain, a wide range of flow parameters to choose from and a wide range of design materials to choose from. One of the advantages of vertical pumps, however, is the relatively small amount of floor space required for installation.

1.Find the spot that allows the pump to run as slow as possible (to reduce wear), but fast enough to keep solids from settling and clogging the lines.To reduce wear, lower the pump’s discharge pressure to the lowest point possible. Follow proper piping principles to ensure a constant and uniform delivery of the slurry to the pump.

Methyl cellulose and HPMC are two types of cellulose-based polymers commonly used in building materials. However, Methyl Cellulose is gradually being replaced by HPMC due to the higher requirements in modern construction. In addition, some suppliers refer to methyl cellulose as the common name for hydroxypropyl methyl cellulose (HPMC) and Hydroxyethyl methyl cellulose (HEMC). We will explore the difference between HPMC and HEMC in later articles.

It is now an EU and FDA-approved food additive and is considered non-toxic to humans.

Residues of cellulose and breakdown products in edible tissues and products from animals fed HPMC are not expected. Although the (partial) degradation of HPMC would eventually occur in some species (ruminants, hindgut fermenters), breakdown products would still likely be of high molecular weight and poorly or not absorbed; the short-chain fatty acids resulting from microbial breakdown of cellulose in the rumen or hindgut will enter the physiological pools of the animals. The consumer would therefore not be exposed to the additive or derived products when consuming edible tissues and products from animals given diets containing HPMC. Consequently, the FEEDAP Panel concludes that the use of HPMC in animal nutrition is of no concern for consumer safety.