metal lined slurry pump manufacturers

Some models can generate discharge pressures up to 260 ft. (80 m).

If youve ever pumped a slurry, you know it can be one of the most challenging fluids to work with. It is abrasive, viscous, sometimes corrosive, and contains a lot of solids. Theres no doubt that the slurry on the pump is hard. But the more you know about whats being pumped, the better your pump selection will be, resulting in longer mean time between failures.xa0Next, the , slurry pump supplier, will share the following content with you.

The company uses advanced computer assistant engineering software to design products and technology, which makes our

Pumping slurry can cause excessive wear and tear on the pump and its components as the mud can clog the suction and discharge lines.

A dredge pump contains a pump casing and an impeller. The impeller is mounted in the pump casing and connected to the drive motor via a gearbox and shaft. The front part of the pump casing is sealed with a suction cover and connected directly to the suction pipe of the dredger. The discharge port of the dredge pump is located near the top of the dredge pump and is connected to a separate discharge line.

- By increasing the size of the worm housing, the speed at which the media moves is reduced. This lower velocity translates into lower wear.