Although the focus of slurry pumps is often on the size and percentage of solids to be pumped, in many applications corrosion resistance is also an important factor in material selection. In such cases, the material chosen must provide adequate resistance to erosion and corrosion.

Dredge Pump

Will solids size pass through the pump?

The selection of a dredge or , slurry pump, can be a challenging process that can be simplified by understanding the main factors behind the smooth operation of a pump. In addition to providing more efficient performance, the right dredge pump requires less maintenance, lower power and a relatively longer life.

Follow proper piping principles to ensure consistent and uniform delivery of mud to the pump.

Settling slurries are formed by coarse particles, which tend to form unstable mixtures. Special attention should be paid to flow and power calculations when selecting a pump. Most slurry applications consist of coarse particles and therefore have a higher abrasion resistance.

I don't see the scientific evidence in the literature that would cause people any concern, said Kaminski.

China is at the forefront of the titanium dioxide industry, with manufacturers like Lomon producing high-quality products such as R996 grade titanium dioxide for the paint industry. Titanium dioxide is a crucial ingredient in paint production, as it provides opacity, brightness, and UV protection to the finished product.

The production of Chinese anatase titanium dioxide involves a series of complex chemical processes, including hydrolysis and calcination of titanium precursors. These processes result in the formation of nanoscale particles of anatase titanium dioxide, which exhibit enhanced properties such as increased surface area and improved reactivity. The size and morphology of these nanoparticles can be controlled during the synthesis process, allowing for the production of tailored materials with specific properties for different applications.

Hemolysis was studied on suspensions of P25TiO₂NPs (0.2 mg/mL and 0.02 mg/mL), vitaminB2@P25TiO₂NPs (0.2 mg/mL and 0.02 mg/mL) and vitamin B2 (0.2 mg/mL and 0.02 mg/mL) were prepared and mixed with 500 μL of anticoagulated blood (donated by Laboratorio de Hemoderivados, UNC) in a rate of 1/10. A solution of NaCl 10% was used as the positive control and PBS as the negative control. Then, the samples were irradiated using the LED described above for 3 and 6 h to simulate the light penetration into the skin. Also, a set of samples was kept in the dark as control. Finally, the samples were centrifuged and the absorbance at 540 nm was measured in the supernatants. The experiment was reproduced twice; the standard deviation was calculated and p-value < 0.05 were considered significant.

Lithopone: an alternative to titanium dioxide