high quality recessed impeller slurry pump factory

Latest articles



Popular articles

Latest articles

Links

  • The characteristics of hexagonal wire mesh: strong structure, flat surface, with good corrosion resistance, oxidation resistance and so on.

  • Large

  • In use, it can be well used in the annealing process to control its degree of hardness, mainly used in the construction industry for binding silk and tying. Its use is certainly not limited to arts and crafts. It is also widely used in the construction industry. Earlier woven lanterns were made of wire, and inside were placed suitable candles, which were hung in front of the door. It was very beautiful to go up at night.

  • The insulation layer of large rolls of galvanized wire and rigid thermal insulation products can be bound with double strands of galvanized iron wire, and the binding interval shall not exceed 400mm. The pipe or corresponding equipment with nominal diameter equal to or greater than 600mm shall stop reinforcement after binding, and the enclosed galvanized steel wire must be winched. The iron or wood rod should be tightened, but the tightening level should be moderate, not too tight or too loose, and not damage the wire. The consumption of wire and steel wire is generally used in drawing process and galvanized disposal.

  • 2. When there are natural barriers such as canals, ponds and lakes on the side of the road, barbed rope protection nets shall not be set up in the section where there is no need to worry about people and livestock entering and illegally occupying the road land.

  • During this process, each time the wire is pulled over, the surface hardens due to the high friction temperature. So basically every time you pull it you have to annealing it in the furnace. On the one hand, it is to reduce the surface hardness. On the other hand, during the process of wire pulling, only the surface is deformed, and the center is unchanged. So there’s a lot of stress inside. Therefore, it is necessary to rely on annealing to eliminate the internal stress, so that the wire becomes soft again to eliminate the stress before being drawn again.

  • Galvanized iron wire can be divided into hot-dip galvanized iron wire and cold galvanized iron wire according to different processing methods. Galvanized iron wire is more prominent in its corrosion resistance. Galvanized iron wire has good toughness and elasticity, the amount of zinc can reach 300 g/square meter, with thick galvanized layer, strong corrosion resistance and other characteristics. Galvanized iron wire products are widely used in construction, handicrafts, wire mesh preparation, the production of galvanized hook mesh, wall mesh, highway guardrail, product packaging and daily civilian and other fields.

  • galvanized

  • In the use of time do not need to carry out daily maintenance and maintenance, not only can save a lot of time, but also can reduce the cost, but also has good stability, strong corrosion resistance, greatly prolong the service life. According to the different process is divided into different kinds, can be selected according to their own needs, has good flexibility and elasticity. The main role of annealing wire is to control its degree of hardness and softness. When making annealing wire, it is made of steel wire.

  • The zinc layer on the galvanized wire has good ductility, can be cold blanking, rolling, bending and other molding without damage to the zinc layer. The zinc layer of galvanized wire with thick zinc layer has fine crystallinity, uniform and no void, and good corrosion resistance. The zinc layer obtained by electrogalvanizing is very pure and corrodes slowly in the gas, liquid and fog of acid and alkali, which can effectively protect the steel matrix. Galvanized layer can also be chromate passivation into a variety of colors, beautiful and generous, with good decoration.

  • barbed

  • Galvanized barbed wire as a safety protection of the metal wall, the galvanized barbed wire device also need to be protected for a long time? And how to protect it? Maintenance and protection of galvanized barbed rope. First, we can start from two aspects. One is about the protection of galvanized barbed rope posts.

  • Stainless steel barbed wire in the way of corrosion is not too, because the surface is not treated but relies on its own raw materials for corrosion resistance, so there will be no chemical reaction.

  • 1. Used for mountain farming, road isolation, large farming enclosure protection, it is recommended that you choose 3mm wire diameter products.

  • Different from the general zinc barbed rope, high zinc barbed rope surface zinc content is very high can reach the former 6-8 times, so in the service life also has a great advantage, ordinary products three or five years began to corrosion and the latter will take longer to change. Stainless steel barbed rope is in the material aspect of protection, so the durability is also better, these two products are long in the service life, but in the price is high.

  • 6, barbed rope protection network layout should be according to the road boundary terrain necessary renovation, flat section level set, slope section slope or step set.

  • The hot plating wire is made of low carbon steel wire rod, which is processed by drawing forming, pickling and rust removal, high temperature annealing, hot dip galvanizing and cooling. Galvanized iron wire has resistance and elasticity, the amount of zinc can reach 300 g/square meter, with thick galvanized layer, strong corrosion resistance and other characteristics. Widely used in construction, handicrafts, wire mesh, highway guardrail, commodity packaging and ordinary civilian and other fields.

  • Post time: 01-09-22

  • Generally, galvanized wire used for welding is required to have a certain hardness. After acceptance of galvanized wire, the first thing to do is to feel the hand, and the other thing is to test on the machine. Because the average user does not have testing equipment, it is also very inconvenient to test on the machine. Use a micrometer to measure the diameter of galvanized wire evenly, and keep it about 0.02mm above and below the contract signing standard, with neat appearance, no leakage plating and no mess.

  • Some customers do not understand the range of application of different styles of barbed rope, so there is a big difference.

  • Galvanized wire often turns black, affecting its beauty. In the process of galvanized, attention should be paid to the air, impurities in the production of steel plate and the health of construction personnel. In fact, it is the problem that will affect galvanized wire. Some simple treatment methods can prevent galvanized silk from turning black or extending the time of turning black in the process of making it, such as: keep the work site dry, reduce and do not use chemicals, and the operator with clean gloves.
  • 2, galvanized wire mesh molding sheet storage ground should be flat, according to the symbolic requirements of the accumulation of regular, height should not exceed 2M, and away from heat sources, avoid exposure.
  • Twisting the barbed wire: twisting the barbed wire in the opposite direction of the main wire. That is, it’s not twisted in one direction. This is called the twisted cord.

  • 2. To avoid galvanized iron wire being gripped by tools like pliers or hardened claws, when the wire suffers from tension or bending stress, scoring or pooping on the surface can lead to damage.
  • Post time: 29-03-23
  • Post time: 24-11-22

  • Hexagonal

  • Galvanized barbed wire (barbed wire) is made of galvanized barbed wire twisted on the main wire, so as to play a protective and isolation role. Among them twist weave way is divided into single twist weave and double twist weave. Construction methods include direct installation and spiral insertion.

  • Post time: 21-10-22

  • In general, the cost of hot dipping zinc is lower than that of other maintenance coatings. The reason is very simple. Other maintenance coatings, such as sand painting, are labor-intensive processes, whereas hot dipping zinc processes are highly mechanized and tightly controlled in-plant construction. Hot dip zinc coating can be visually and briefly tested for non-destructive coating thickness.

  • Pet