china slurry pump parts rubber liner

Latest articles



Popular articles

Latest articles

Links

  • Post time: 27-05-22
  • Stainless steel wire drawing is a metal working (stainless steel) process, is a popular surface treatment technology in the stainless steel and aluminum products industry today. It is the effect of drawing stainless steel and aluminum products. So galvanized wire and stainless steel wire are two different products. Defects such as surface film and surface inclusion can be found and treated by conventional techniques in order to locally remove the surface film and surface inclusion from the surface of galvanized iron wire. Excess foam is formed when soap and surfactants such as saponified fats are brought into the tank.

  • Long-term exposure to such impurities will result in transition and gap corrosion. The direct solution to this phenomenon is to strengthen the coating of the material to avoid corrosion. Improve the quality of galvanized iron wire, can use the wire that had plated zinc beforehand to pull out when making galvanized iron wire, won’t appear the phenomenon of bad mechanical properties. The toughness of the wire is 15 to 25 per cent higher than that of the drawn and galvanized wire, and in some cases slightly stronger than that of the polished wire.

  • Galvanized wire coating is galvanized, aluminum plated, coated with nylon or plastic, etc. Zinc is divided into thin coating of steel wire after plating and thick coating of galvanized steel wire after drawing. The mechanical properties of thick coating are reduced compared with smooth steel wire rope, which should be used in severe corrosion environment. It is more resistant to corrosion, wear and heat than galvanized wire rope, using the first plating and then drawing method of production. Coated nylon or plastic wire rope is divided into two kinds of coated rope and coated stock after the rope.

  • There is no adhesion test of powder spraying or fluorocarbon spraying on packaged galvanized wire, but there are two points for reference: first, in sealed or air-free environment, non-metallic volatiles can corrode zinc coating; Second, zinc at higher than 230 degrees (c) will cause the matrix metal brittle. And powder spraying and fluorocarbon spraying are to be baked at a higher temperature and in a sealed environment, causing rapid corrosion of zinc, resulting in loose corrosion film resulting in coating adhesion decline, and even lead to (matrix) steel wire brittle situation may exist.

  • In want to use barbed wire fence ground road at both ends of each set up a stake, and then from the two stakes, every 30m to set up a stake, until the installation of the line is full of stakes, so installed barbed wire net is a straight line.

  • Powder coating color is divided into: blade thorn rope blue, grass green, dark green, yellow. Spray blade gill net is made of hot-dip galvanized steel plate or stainless steel sheet stamped out of sharp knife sheet, high tension galvanized steel wire or stainless steel wire as core wire combination of blocking devices. Because the shape of the thorn rope is not easy to contact, so it can reach excellent protective barrier effect. The primary raw materials of products are galvanized sheet, stainless steel plate, high quality low carbon steel wire (electric galvanized, hot galvanized, coated plastic, plastic spray) wire, blue, green, yellow and other colors.

  • 3. When you travel with your dog, it will not cause anxiety to some friends because the dog is scattered in the car, or it will affect safe driving and bring risks.

  • There are a variety of arc, non-divergence Angle and non-divergence height ladder types installed to provide ideal treatment plans. It can be used together with the appearance and the common design of the trackless active shift door, forming a harmonious and intact whole.

  •  

  • The silver powder is actually a mixture of aluminum powder and polymer after painting the film, the film is brittle, easy to appear adhesion problems, and corrosion resistance is also slightly poor. Galvanizing refers to the surface of metal, alloy or other materials coated with a layer of zinc to play the role of beautiful, rust prevention and other surface treatment technology. Zinc dissolves easily in acids and also in bases, so it’s an amphoteric metal. Zinc changes little in dry air.

  • Post time: 16-05-23
  • Post time: 17-05-22
  • 6. It’s easy for your dog to get used to a strange place as long as it has a home he’s familiar with, so you can take your dog on a trip instead of leaving him at home.
  • The management system of the rinsing water after the steel wire pickling should be regularly and regularly discharged after the rinsing water, and the rinsing water should be kept clean and low acid value as far as possible. The pH control is more appropriate. The concentration of plating aid should not be too high. Hot plating wire must be added ammonium chloride and zinc chloride according to the data of laboratory analysis, and the specific gravity of the composite solution is controlled in the range of 50~80g/L. The addition of ammonium chloride or zinc chloride raw materials without the results of laboratory analysis shall be subject to criticism and education, and economic treatment if necessary.
  • Post time: 02-08-22
  • Galvanized wire A stable layer of zinc is coated on the outside of the wire, which is used to protect the wire and make the wire service life longer. When producing galvanized wire, the wire is pickled. Pickling is to use some acid mist or acid to wash off some oxides on the surface of iron, that is, rust, and some other corrosive substances, to achieve the purpose of cleaning iron, so that zinc will fall off when galvanizing.

  • In strict accordance with the multi-pass small compression rate drawing, the total compression rate is 96.48%, reducing the scraping of zinc layer. The whole wire drawing die is made of tungsten steel die and polycrystalline die. The Angle of the working cone of the wire drawing die is 12° ~ 16°, and the length of the sizing belt is 0.15 of the diameter of the wire, so as to ensure that the deformation of the zinc layer is basically synchronous with the steel wire substrate.

  • One is the frame isolation net, guardrail net with frame, frame using material cold plate belt welded into the square tube, usually 2*3 thickness 1.2 thick, the middle for low carbon steel wire welding mesh, wire diameter can choose another welding aperture can also choose, for example, customers want good quality long service time, you can choose thick wire diameter, small welding aperture, Such mesh is not only high quality, but also long service life, customized mesh and frame after welding, surface treatment to reach the customer needs of goods.

  • Post time: 13-02-23

  • Stainless

  • Paint on the galvanized layer, the binding force between each other and the baking temperature of the paint has a great relationship, after galvanized coating alkyd paint, adhesion is no problem. Galvanized amino paint, paint adhesion is not good. Do two bottom two surface, adhesion is ok, if the two bottom two surface to two bottom three surface, that is, more paint, more baking once, again test adhesion is very poor, poor to the paint from the galvanized layer of pieces torn off.

  • As a very important product of the barbed rope factory blade barbed rope can be said to have made a great contribution, but often due to the opaque processing process often do not get the trust of customers.

  • The production process of stainless steel blade and galvanized blade is basically similar. The blade size is usually determined according to the mold.